![]() If you don't have solar panels, batteries or generators attached, you have no power for the wheels to move. Johnno is right, there is no throttle setting for wheels, but you do need power. You can also remove the front wheels from the brake action group, just be careful braking in reverse! If your rover is tumbling while braking, try tapping the break key in quick bursts. The only thing that will stop wheels moving is the brakes. If you empty the gas tank, the car will still move, just not under the power of the engine. Disabling the motors will not stop it rolling, that will just disable the wheels ability to move what it's attached to. I am in some hilly terrain which makes it hard to see the horizontal, but I drove for a while in one direction and did a 180 and drove all the way back, so I don't think I'm rolling downhill! I don't have SAS or ASAS enabled.Īnything with rover wheels attached will roll if on uneven terrain. I can even disable the motor for all 4 wheels and it keeps on going. I have been unable to stop it from moving (I just end up rolling it and exploding). I think the throttle is stuck on at a low amount, as my rover just starts off rolling and picks up some speed and actually rolls up some hills. ![]() I can use 4 and 6 to turn left and right, but here's the thing, no amount of 8 and 5 change the throttle. I was using WASD until I realized it was also pitching the rover, so following a tip on the wiki, I remapped the rover controls to numpad 8456. ![]() Rover is basically just 4 wheels stuck to a metal plate, some solar panels and a kerbal in a control seat. So I just landed my first rover on the Mun and I can't seem to control it's throttle at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |